Spring 2019 Class Schedule (FLC)



Back to Previous Page

ENGR 303    Introduction to Logic Design    4 Units

Prerequisite: None.
Advisory: Some previous exposure to programming at the high school level or above.
Course Transferable to CSU
Hours: 54 hours LEC ; 54 hours LAB
Description: This is an introductory course in the fundamentals of designing digital computer hardware. This course covers: logic gates, binary number system, conversion between number systems, Boolean algebra, Karnaugh maps, combinational logic, digital logic design, flip-flops, programmable logic devices (PLDs), counters, registers, memories, state machines, designing combinational logic and state machines into PLDs, and basic computer architecture. The lab is design oriented and emphasizes the use of software equation entry tools, schematic entry, and logic simulation tools. Lab assignments are design oriented. This course is required for Electrical/Electronics Engineering and Computer Engineering majors at some universities. This course is also helpful for Computer Science majors, electronics technicians, and for students wishing to sample computer engineering.

Schedule: Full Term, Jan 19-May 22

MW05:00PM-06:20PMLECC.BrownFLC MAIN FL5 916071Textbook
MW06:30PM-07:50PMLABC.BrownFLC MAIN FL5 9

ENGR 312    Engineering Graphics    3 Units

Prerequisite: None.
Advisory: MATH 110
Course Transferable to UC/CSU
Hours: 36 hours LEC ; 72 hours LAB
Description: This course applies the graphical tools needed to analyze, interpret, and solve engineering problems. The engineering design process is taught using manual tools and computer-aided design and drafting (CADD) tools to solve typical engineering problems. Topics include descriptive geometry, vector graphics, orthogonal projection, primary and secondary auxiliary views, geometric dimensioning and tolerancing (GD&T), 3D solid modeling, and an introduction to finite element analysis (FEA) tools. This course is intended for mechanical and civil engineering majors, but may also be required for other programs.

Schedule: Full Term, Jan 19-May 22

MW02:00PM-03:20PMLECD.RossFLC MAIN FL5 919935Textbook
MW03:30PM-04:50PMLABD.RossFLC MAIN FL5 9

ENGR 400    Introduction to Electrical Circuits and Devices    3 Units

Prerequisite: PHYS 421 with a grade of "C" or better
Corequisite: MATH 420
Course Transferable to UC/CSU
Hours: 54 hours LEC
Description: This course will provide engineering students with circuit analysis concepts and applications that will be of value in any engineering field as well as a solid foundation for electrical engineering and related majors. The course includes the analysis of circuits with resistors, inductors, capacitors, and independent and dependent voltage and current sources. Many analysis techniques will be applied to DC and AC circuits. Differential equations will be used to find the transient response of circuits. Power calculations will be performed on both DC and AC circuits, including an introduction to three-phase AC power. This course is required for most engineering Bachelors of Science degrees. (C-ID ENGR 260)

Schedule: Full Term, Jan 19-May 22

TTh01:00PM-02:20PMLECD.RossFLC MAIN FL1 20416180Textbook

Spring 2019 Class Schedule

Updated: December 18, 2018