Spring 2010 Class Schedule (FLC)

Back to Previous Page

ENGR 303    Introduction to Logic Design    4 Units

Prerequisite: None
Advisory: Any previous or concurrent programming class. MATH 120.
Course Transferable to CSU
Hours: 54 hours LEC ; 54 hours LAB
Description: This is an introductory course in the fundamentals of designing digital computer hardware. This course covers: logic gates, binary number systems, conversion between number systems, Boolean algebra, Karnaugh maps, combinational logic, digital logic design, flip-flops, programmable logic devices (PLDs), counters, registers, memories, state machines, designing combinational logic and state machines into PLDs, and basic computer architecture. Lab emphasizes the use of a software equation entry tool, the use of schematic entry, and the use of a logic simulation tool. Lab assignments are design oriented. Required for Electrical/Electronics Engineering and Computer Engineering majors. Helpful for Computer Science majors. Recommended for students wishing to sample computer engineering, and for current and future electronics technicians.

Schedule: Full Term, Jan 16-May 19
MW        02:00PM-03:20PM LEC D.Ross               FLC MAIN FL5 11          17315 
MW        03:30PM-04:50PM LAB D.Ross               FLC MAIN FL5 11            

ENGR 400    Introduction to Electrical Circuits and Devices    3 Units

Prerequisite: PHYS 421. Grade of "C" or better required to meet prerequisite.
Course Transferable to UC/CSU
Hours: 54 hours LEC
Description: This course will provide engineering students with circuit analysis concepts and applications that will be of value in any engineering field as well as a solid foundation for electrical engineering and related majors. The course includes the analysis of circuits with resistors, inductors, capacitors, and independent and dependent voltage and current sources. Many analysis techniques will be applied to DC and AC circuits. Differential equations will be used to find the transient response of circuits. Power calculations will be performed on both DC and AC circuits, including an introduction to three-phase AC power. This course is required for most engineering Bachelors of Science degrees.

Schedule: Full Term, Jan 16-May 19
TTh       01:00PM-02:20PM LEC D.Ross               FLC MAIN FL5 11          17721 

Spring 2010 Class Schedule

Updated: April 30, 2010