Spring 2013 Class Schedule (ARC)



Back to Previous Page

SHME 101    Sheet Metal Apprenticeship II    3.3 Units

Prerequisite: None.
Enrollment Limitation: Registered Sheet Metal Apprentice
Hours: 40 hours LEC ; 58 hours LAB
Description: This course an introduction to sheet metal field installation with an emphasis in basic sheet metal layout, parallel and radial line development and an introduction to triangulation. Topics include soft soldering and drafting of sheet metal prior to fabrication.

Schedule: Other Term, Feb 04-Apr 19
TBA       TBA             LEC TBA                   TBA TBA                 20671 
Textbook
TBA       TBA             LAB TBA                   TBA TBA                   

Schedule: Other Term, Feb 11-Apr 26
TBA       TBA             LEC TBA                   TBA TBA                 20673 Textbook
TBA       TBA             LAB TBA                   TBA TBA                   


SHME 111    Sheet Metal Apprenticeship IV    3.3 Units

Prerequisite: None.
Enrollment Limitation: Registered Sheet Metal Apprentice
Hours: 40 hours LEC ; 58 hours LAB
Description: This course covers advanced pattern development, architectural sheet metal principles, flashing, and gutters. Topics include hoisting and rigging, as well as installation of fire and smoke dampers.

Schedule: Other Term, Jan 07-Apr 05
TBA       TBA             LEC TBA                   TBA TBA                 20675 
Textbook
TBA       TBA             LAB TBA                   TBA TBA                   


SHME 131    Sheet Metal ApprenticeshipVIII    3.3 Units

Prerequisite: None.
Enrollment Limitation: Registered Sheet Metal Apprentice
Hours: 40 hours LEC ; 58 hours LAB
Description: This course covers testing, adjusting, and balancing of heating, ventilating, and air conditioning (HVAC) systems. Topics include advanced drafting elevation views of shaft duct systems and complete takeoff of a HVAC system with cost, quantity and weight.

Schedule: Other Term, Jan 14-Mar 08
TBA       TBA             LEC TBA                   TBA TBA                 20677 
Textbook
TBA       TBA             LAB TBA                   TBA TBA                   


SHME 298    Work Experience in Sheet Metal Apprenticeship    1-4 Units

Prerequisite: None.
Enrollment Limitation: Be in a sheet metal apprenticeship.
Hours: 300 hours LAB
Description: Supervised work in sheet metal apprenticeship for the purpose of developing specific skills to meet the goals and objectives of the sheet metal Joint Apprenticeship and Training Committee (J.A.T.C.). Students will be completing work experience hours at approved training sites. SHME 298 may be taken for a total of 16 units.

Schedule: Full Term, Jan 19-May 22
TBA       TBA             LAB TBA                   TBA TBA                 20478 
Textbook


Spring 2013 Class Schedule

Updated: May 30, 2013